Set the VCT in the room where you plan on installing it 72 hours before installation. This will let the vinyl acclimate to the temperature and humidity of the room before it is installed, making for a stronger installation.
Lay out the VCT right on the floor where it will be installed to determine the pattern you want to use and where the cuts will be placed. Set the first tile in the center of the wall furthest from the door and the next tiles out evenly to each side. This will give a balanced installation with full tiles in the most visible wall and cuts buried in the corners. Cut the VCT to fit the edges of the room with a vinyl tile cutter.
Set the VCT on the plate of the cutter and depress the handle as if you were operating a paper cutter to make smooth cuts in the VCT. Return the tiles to the edges of the layout to double check their fit before installing. Take up the tiles in the opposite order that you will lay them down.
LVT is made of vinyl, making it a durable hard surface with a protective coating. However, VCT consists of only a small amount of vinyl with limestone or other materials resulting in a more porous option meaning it requires constant maintenance to maintain its structure and appearance. Although not as widely used today as it was 10 years ago, VCT is still used in many healthcare and education applications due to its long life and low initial cost.
If material cost is a major concern, VCT is a functional and durable commercial flooring option worth considering.
The material cost of the VCT is low, but it requires routine maintenance to maintain the finish. Identify the type of tile you have. Use a thin-set product to install ceramic tile over existing tiles. This is a mixture of cement, fine-grain sand, and water that will adhere the new tile to the old. When it comes to mortar, latex or epoxy options are best for installing tile over tile. Also, consider that doors, cabinets, and other hardware might need to be reworked or replaced with new ones to compensate for the higher floor.
Installing ceramic tile over vinyl or linoleum surfaces can be more complicated than expected and probably should be avoided whenever possible. However, if you can't remove the old surface or otherwise decide to install over it, lay a backer board with thin-set over the old surface to serve as your new subfloor material. It is important to use the thin-set recommended by the backer board manufacturer, make sure all loose adhesive is removed from the surface, and verify that a good bond to the substrate can be achieved.
For cutback adhesive residue, verify that the thin-set manufacturer's mortar is compatible. It's not uncommon for subfloors to develop low spots or other imperfections over time, but before installing a new floor over one, it's very important to address these issues and make certain the subfloor is level.
Low spots can be filled in with a floor-patching mixture that then can be sanded once it has hardened. When actually laying the tile, measure out an area away from walls and other border areas where you can install full squares of tile. Once you have allowed this to set and can walk on it, measure the space you have along walls and other border areas, minus the grout line, and mark where tiles need to be cut to fill these odd spaces.
Try to avoid sliver pieces—thin, cut pieces along the perimeter of the space. Plan the layout so you can have the largest possible pieces along the perimeter, limiting the number of tiles that need to be cut as much as possible. Actively scan device characteristics for identification. Use precise geolocation data. Select personalised content. Create a personalised content profile. Measure ad performance. Select basic ads.
0コメント